Samsung GT-I9300 XXUGMK6_OXAGMK6 firmware



Original Samsung GT-I9300 was Flash Firmware I9300XXUGMK6_OXAGMK6 which is android version 4.3 was successfully revive from bootloop.
The device flash the firmware by using odin tool and you can see figure below step by step.

STEPS

  1. Download Odin 3.09/Driver and read more step how to use ⇨ HERE.
  2. Download Firmware Navigate I9300XXUGMK6_OXAGMK6 ⇨ HERE.
  3. Extract the firmware inside the folder of odin tool , note: rar no password
  4. Open Odin 3.09 and click the AP tab and load the AP_I9300XXUGMK6_2168382_REV00_user_low_ship_.tar.md5.
  5. (Optional )Load the CP as modem file and CSC as CSC file to prevent unknown baseband problem after program device
  6. Connect the device in Download mode refer how to download mode in step 1
  7. Check the ID:COM of odin tools if the device was detected, If not install drivers refer how to connect in step 1
  8. If device detected, make it check option autoreboot F.reset time then hit START button and wait till finish.
Figure of tool


After finish flash you see log on id com showing is PASS on odin tool and the device is automatic reboot to recovery erasing userdata\catch.
Note after finish program your device all userdata was lost.
Extract the downloaded compress file using 7 ZIP or winrar and provide given password if asked, Do it at your own risk, After flashing ! the device is set automatic in reset condition, All your user data is lost. Make sure back-up first before to proceed flashing your phone.

A Smartphone Software repairing


ABOUT THIS BLOG PRIVACY POLICY

Previous
Next Post »
0 Comments